5LAll ceramic Sander

NTZr-5L All Ceramic Sand Grinding Product Description:

The Sander is designed for the pre dispersion and dispersion of high viscosity materials. It is suitable for fine and large flow grinding of high viscosity materials. It is an ideal equipment for producing offset printing ink and high viscosity materials. The rod Sander is suitable for paints, inks, pigments, color pastes, dyes, magnetic recording materials and other materials.

Features of this machine:

1. Rod pin grinding structure, which can shear and impact materials.

The conical design of the outer cylinder and rotor is suitable for fine grinding with a large amount of medium to high viscosity.

3. Separate dynamic separation, gap screen dynamic separation, capable of high flow discharge without blockage.

4. The container has a double end mechanical seal, which is easy to install, compatible with coolant and materials, and reduces the risk of leakage.

5. Inner tube structure, easy to replace.

6. There are two forms: straight tube and conical tube.

Installation of sand grinding lining plate:

Before installing the lining board, the dust on the tube should be cleaned first. Then the lining plate shall be checked and trimmed. Its back and surrounding shall be trimmed and leveled with grinding wheel as appropriate. The bolt hole shall be sand cleaned and cast with flash to enable the bolt to penetrate smoothly and meet the installation requirements. When installing the lining plate, a layer of 1:2 cement mortar shall be applied between the cylinder wall and the lining plate of the vane Sander, and the lining plate bolts shall be tightened wet. The gaps between the liners are also wiped with mortar.

The bolts for fixing the lining plate should be carefully padded with sealing pads to prevent leakage of mineral slurry or powder.

The cylinder liner cannot form a circular gap.

The feeding test can only be conducted after the cement mortar has solidified to meet the strength requirements. When the lithium battery Sander is running, if the bolt is loose, it should be tightened in time.

The parts that come into contact with the material can be selected.

Optional inner cylinder materials: special steel, stainless steel, polyurethane, silicon carbide, electroplated hard chromium

Material selection for rod pins: special steel, alloy steel, zirconia ceramic